Odd Hour Mending the mechanical hour

Bench status Taking spring commissions

Bench hours

Tuesday to Saturday

10 in the morning until the light goes, by appointment on Mondays.

Bench

Recently

Hello, we’re Odd Hour, a small repair bench for clocks that have stopped trusting themselves.

Started by two watchmakers in a former print shop, we take apart, clean and set going again the clocks people inherit, find at markets or forgot in the loft. Nine out of ten pieces we see are older than the house they live in.

Bench

Profile

Odd Hour is a two-person workshop that repairs mechanical clocks and pocket watches, from a single broken pivot to a full overhaul of a tall-case movement.

The bench also works as an open notebook: every repair is written up, so owners know what was done, why, and how to keep it running for the next forty years.

Bench camera

On the bench this week

A small screen follows you down the page with whatever is open on the bench. Tap it to hold a frame, or pick one from the list.

  1. Pocket watch, cleaned and oiled
  2. Pewter mantel clock, new hands
  3. Porcelain table clock, case reglued
  4. Gilt bracket clock, full overhaul
  5. Enamel dial, set back in its bezel
Woodblock print of a pocket watch on its chain Pewter mantel clock with a square dial Ornate porcelain table clock Gilt bracket clock on its wall shelf Dark enamel watch dial with gold numerals

Repairs

How a clock goes through

Most pieces spend three to eight weeks with us, from the first look under the loupe to the day they tick on your own wall.

Process

Drop-off & Diagnosis

Bring the clock in, or send photographs first. We open the case with you there, listen to it, and write down every fault we can find before we promise anything.

If the movement is past saving we say so on the day, and point you to a case-maker or a collector who can give it a second life.

Process

Strip & Clean

The movement comes apart down to the last screw. Plates and wheels are washed, pivots are polished, and worn holes are marked for bushing.

Every part is laid out on a numbered tray and photographed, so the clock goes back together exactly as it left the maker.

Process

Mend & Reassemble

Broken teeth are replaced, springs are renewed and missing pieces are cut by hand on the lathe. Then the movement is rebuilt and oiled with the lightest touch it will take.

Process

Regulate & Return

Every clock runs on the test stand for at least ten days while we set its beat and rate. When it keeps time within a minute a week, it comes home with a written note and a year of free adjustments.

Bench

Recently

Work

Kept running for

Bench

Repairs

Bench

We look after

Rates

Two ways to pay

Pieces are quoted after the first look, never before. Most owners choose a single repair; collections and institutions tend to keep us on a standing visit.

Rates

Single repair

From $180 a piece

  • Written diagnosis on the day
  • Fixed quote before work starts
  • Ten days on the test stand
  • One year of free adjustments

Rates

Standing visit

$95 an hour, booked monthly

  • Winding and setting on site
  • Seasonal change of the hour
  • Small repairs on the spot
  • A logbook kept for every clock

Rates

Bench Notes

Short write-ups of the repairs that taught us something.

  1. Bench Notes IV: the clock that ran backwards
  2. Bench Notes III: a fusee chain, link by link
  3. Bench Notes II: oil, and how little of it
  4. Bench Notes I: why we never use a quartz insert