Plain Machines

A field manual for the machines on your kitchen counter. Drawn and annotated at the Slow Bench.

FIG_001 [ Stovetop coffee pot ] (c) 1933 Knob 1 Lid 2 Spout 3 Upper chamber 4 Handle 5 Rubber gasket 6 Filter plate 7 Funnel basket 8 Boiler 9 Safety valve 10

Fig. 001 / Parts list

The stovetop pot, taken apart.

Ten parts, no moving ones. Water in the boiler turns to steam, steam has nowhere to go but down, and the water it pushes has nowhere to go but up.

  1. 01KnobBakelite
  2. 02LidAluminium
  3. 03SpoutCast in
  4. 04Upper chamberAluminium
  5. 05HandleBakelite
  6. 06Rubber gasketReplace yearly
  7. 07Filter plateSteel
  8. 08Funnel basketAluminium
  9. 09BoilerAluminium
  10. 10Safety valveBrass

A kettle has no idea what a hundred degrees is. What it has is a small disc made of two metals pressed together, sitting at the bottom of a tube. When steam finally reaches it, one metal grows faster than the other and the disc snaps inside out.

FIG_002 Click t = 100°C

That snap is the click you hear from the next room. No sensor, no chip, no number anywhere. Just two metals that disagree about heat.

An induction hob is stranger. Under the glass sits a flat coil of copper, and under the coil a layer of ferrite tiles that keep the magnetic field pointing up, toward your pan, instead of down into the drawer of takeaway menus.

FIG_003 Glass Coil Ferrite

The glass never gets hot on its own. The pan does, because the field stirs up currents in its base and the steel resists them. Lift the pan and there is nothing left to heat.

If you have ever taken a toaster apart on the kitchen floor, this is for you.

This is not a repair guide and it will not save you money. It is a manual for things that already work, written to explain why they do.

Most of the machines in a kitchen were finished decades ago. Nobody is disrupting the pepper mill. That makes them good teachers: every part is still there for a reason, and you can see all of them.

You do not need to be an engineer. There are a lot of drawings, and the drawings do most of the talking. You only need to be the kind of person who looks under things.

FIG_006 [ Electric kettle, section ] (c) 1955 Spout Water line Heating plate Bimetal disc Lid Steam tube Switch

First Printing

The manual ships in parts while it is being drawn. Reserve a copy now and each new chapter reaches you the week it leaves the bench.

Reserve a copy ($48)

Just curious? Read two sample chapters

Table of Contents.v0.7

1. Heat and water

2. Cold

3. Things that spin

4. Time

5. Small mechanisms

6. Misc

Current progress:

Finished chapters:
15 / 21
Words so far:
55.3k
Drawings/chapter:
12
Est. word count:
78.0k
Parts labelled:
1406
Screws lost:
7

Common Questions.

In:

Will there be a paper edition?

Out:

Yes, once the digital one is actually done.

A printed manual wants thick paper, a lay-flat spine and one extra ink for the blue. That takes money and patience, so it comes last.

Anyone who reserves the full digital edition gets first call on the print run.